Command Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 6 DHCP Configuration Commands
Huawei Technologies Proprietary
6-35
DHCP ACK packets received: 0
DHCP NAK packets received: 0
DHCP packets sent to servers: 0
DHCP packets sent to clients: 0
Unicast packets sent to clients: 0
Broadcast packets sent to clients: 0
6.3.9 display dhcprelay-security
Syntax
display dhcprelay-security [ ip-address ]
View
Any view
Parameter
ip_address: Specifies security-specific address map entry to be viewed by specifying
the IP address in it.
Description
Using the display dhcprelay-security command, you can view information of address
map used for security check by DHCP relay.
Example
# Display information of the address map used for security check by DHCP relay.
<Quidway> display dhcprelay-security
IP Address MAC Address IP Address Type
1.1.1.1 00e0-0000-0000 Static
6.3.10 ip relay address
Syntax
Following is the command for configuring in VLAN interface view the DHCP server
address to which the current VLAN interface relays packets:
ip relay address ip-address
undo ip relay address { ip-address | all }
Following is the command for configuring in system view DHCP server address to
which multiple VLAN interfaces relay packets:
ip relay address ip-address { interface vlan-interface vlan_id [ to vlan-interface
vlan_id ] | all }
To Next Page
Loading...
