Command Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 2 ARP Configuration Commands
Huawei Technologies Proprietary
2-7
Description
Using debugging arp packet command, you can enable ARP debugging. Using undo
debugging arp packet command, you can disable the corresponding ARP debugging.
By default, undo ARP debugging is enabled.
For the related command, see arp static, display arp.
Example
# Enable ARP packet debugging.
<Quidway> debugging arp packet
*0.771346-ARP-8-S1-arp_send:Send an ARP Packet, operation : 1,
sender_eth_addr :
00e0-fc00-3500,sender_ip_addr : 10.110.91.159, target_eth_addr :
0000-0000-0000
, target_ip_addr : 10.110.91.193
*0.771584-ARP-8-S1-arp_rcv:Receive an ARP Packet, operation : 2,
sender_eth_addr
: 0050-ba22-6fd7, sender_ip_addr : 10.110.91.193, target_eth_addr :
00e0-fc00-3
500, target_ip_addr : 10.110.91.159
Table 2-1 Output description of the debugging arp packet display
Field Description
operation
Kind of ARP packets: 1 ARP request packet; 2 ARP reply
packet
sender_eth_addr Ethernet address of the sender
sender_ip_addr IP address of the sender
target_eth_addr
Target Ethernet address. If the packet is ARP request packet,
the target IP address will be 0
target_ip_addr Target IP address
2.1.10 display arp
Syntax
display arp [ dynamic | static | ip-address ]
View
Any view
To Next Page
Loading...
Need help?
General
