Command Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 2 MAC Address Table Management Commands
Huawei Technologies Proprietary
2-3
undo mac-address [ static | dynamic ] [ [ mac-addr ] interface {interface-name |
interface-type interface-num } vlan vlan-id ]
View
System view
Parameter
static: Static table entry, lost after resetting switch.
dynamic: Dynamic table entry, which will be aged.
mac-addr: Specify the MAC address.
interface-type: interface type;
interface-num: interface number;
interface-name: interface name;
vlan-id: Specify the VLAN ID.
Description
Using mac-address command, you can add/modify the MAC address table entry.
Using undo mac-address command, you can cancel MAC address table entry
If the input address has been existed in the address table, the original entry will be
modified. That is, replace the interface pointed by this address with the new interface
and the entry attribute with the new attribute (dynamic entry and static entry).
All the (MAC unicast) addresses on a certain interface can be deleted. User can choose
to delete any of the following addresses: address learned by system automatically,
dynamic address configured by user, static address configured by user.
Because the address table is shared in the VLAN domain, you need specify the VLAN
of the multicast address and the port of the unicast address, when adding entries to the
address table.
For the related commands, see display mac-address.
Example
# Configure the port number corresponding to the MAC address 00e0-fc01-0101 as
Ethernet0/1 in the address table, and sets this entry as static entry.
[Quidway] mac-address static 00e0-fc01-0101 interface ethernet 0/1 vlan 2
2.1.4 mac-address max-mac-count
Syntax
mac-address max-mac-count count
undo mac-address max-mac-count
To Next Page
Loading...
Need help?
General
