Huawei quidway s3526 series

Command Manual - Getting Started
Quidway S3500 Series Ethernet Switches Chapter 1 Logging in Switch Commands
Huawei Technologies Proprietary
1-23
Example
# Enter system view from user view.
<Quidway> system-view
[Quidway]
1.1.30 telnet
Syntax
telnet { hostname | ip-address } [ service-port ]
View
User view
Parameter
hostname: Specifies the host name of the remote switch. It is configured using the ip
host command.
ip-address: Specifies the IP address of the remote switch.
service-port: Designates the TCP port on the remote switch providing Telnet service,
ranging from 0 to 65535.
Description
Using telnet command, you can log in to another switch from the current one via telnet
for remote management. To terminate the Telnet logon, press <Ctrl+]>.
By default, when the service-port is not specified, the default telnet port number is 23.
For the related command, see display tcp status.
Example
# Log in to switch Quidway2 at 129.102.0.1 from the current Quidway1 switch.
<Quidway1> telnet 129.102.0.1
<Quidway2>
1.1.31 user-interface
Syntax
user-interface [ type ] first-number [ last-number ]
View
System view