Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA & RADIUS Protocol Configuration Commands
Huawei Technologies Proprietary
3-37
View
RADIUS scheme view
Parameter
ip-address: IP address, in dotted decimal format. By default, the IP addresses of
second authentication/authorization is at 0.0.0.0.
port-number: Specifies the UDP port number, ranging from 1 to 65535. By default, the
authentication/authorization service is provided via UDP 1812
Description
Using secondary authentication command, you can configure the IP address and
port number for the second RADIUS authentication/authorization. Using undo
secondary authentication command, you can restore the IP address and port number
to default values.
For detailed information, read the Description of the primary authentication
command.
For the related commands, see key, radius scheme, state.
Example
# Set the IP address of the second authentication/authorization server of RADIUS
scheme, “huawei”, to 10.110.1.2 and the UDP port 1812 to provide RADIUS
authentication/authorization service.
[Quidway-radius-huawei] secondary authentication 10.110.1.2 1812
3.2.22 server-type
Syntax
server-type { huawei | iphotel | portal | standard }
undo server-type
View
RADIUS scheme view
Parameter
huawei: Configures the switch system to support the RADIUS server of Huawei type,
which requires the RADIUS client end (switch system) and RADIUS server to interact
according to the private RADIUS protocol regulation and packet format of Huawei
Technologies Co., Ltd.
iphotel: Configures the switch system to support the RADIUS server of IP Hotel type,
which requires the RADIUS client end (switch system) and RADIUS server to interact
To Next Page
Loading...
Need help?
General
