Command Manual - Multicast
Quidway S3500 Series Ethernet Switches Chapter 2 IGMP Snooping Configuration Commands
Huawei Technologies Proprietary
2-5
removes the port from the multicast group directly at receiving the IGMP Leave packet.
The fast remove function saves bandwidth when only one user remaining at the port.
Note that, this function takes effect on condition that the client supports IGMP V2. After
configuring this command, when there are multiple users at one port, the leaving of one
user may cause the loss of multicast service of other users in this group.
Example
# Enable the the fast remove function on Ethernet 0/1.
[Quidway-Ethernet0/1] igmp-snooping fast-leave
2.1.6 igmp-snooping group-limit
Syntax
igmp-snooping group-limit limit
undo igmp-snooping group-limit
View
Ethernet port view
Parameter
limit: The maximum number of multicast groups on a port, in the range of 0 to 1000. The
default value is 1000.
Description
Using igmp-snooping group-limit command, you can set the maximum number of
multicast groups permited on a port. Using undo igmp-snooping group-limit
command, you can restore the default value.
By default, the maximum number of multicast groups permited on a port is unlimited.
Example
# Set the maximum number of multicast groups permited on Ethernet0/1 is 256.
[Quidway-Ethernet0/1] igmp-snooping group-limit 256
2.1.7 igmp-snooping group-policy
Syntax
igmp-snooping group-policy acl_number vlan vlanid
undo igmp-snooping group-policy vlan vlanid
View
Ethernet port view
To Next Page
Loading...
Need help?
General
