Command Manual - Getting Started
Quidway S3500 Series Ethernet Switches Chapter 1 Logging in Switch Commands
Huawei Technologies Proprietary
1-19
z You will be asked to confirm before executing this command on any legal user
interface.
Example
# Disable terminal service on the vty user interface 0 to 4 after logging in to the switch
via user interface 0.
[Quidway] user-interface vty 0 4
[Quidway-ui-vty0-4] undo shell
# The following message will be displayed on the Telnet terminal after logon.
Connection to host lost.
1.1.24 speed
Syntax
speed speed-value
undo speed
View
User interface view
Parameter
speed-value: Specifies the transmission rate on the AUX (Console) port in bit/s, which
can be 300, 600, 1200, 4800, 9600, 19200, 38400, 57600, or 115200. The default rate
is 9600bit/s.
Description
Using speed command, you can configure the transmission rate on the AUX (Console)
port. Using undo speed command, you can restore the default rate.
This command can only be performed in AUX user interface view.
Example
# Configure the transmission speed on the AUX (Console) port as 9600bit/s.
[Quidway-ui-aux0] speed 9600
1.1.25 stopbits
Syntax
stopbits { 1 | 1.5 | 2 }
undo stopbits
To Next Page
Loading...
Need help?
General
