Command Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 5 SNMP Configuration Commands
Huawei Technologies Proprietary
5-16
For the related commands, see snmp-agent trap enable, snmp-agent target-host,
snmp-agent trap life.
Example
# Configure the queue length to 200.
[Quidway] snmp-agent trap queue-size 200
5.1.20 snmp-agent trap source
Syntax
snmp-agent trap source vlan-interface vlan-id
undo snmp-agent trap source
View
System view
Parameter
vlan-id: Specify the VLAN interface ID, ranging from 1 to 4000.
Description
Using snmp-agent trap source command, you can configure the source address for
sending Trap. Using undo snmp-agent trap source command, you can cancel the
source address for sending Trap.
Example
# Configure the IP address of the VLAN interface 1 as the source address for
transmitting the Trap packets.
[Quidway] snmp-agent trap source vlan-interface 1
5.1.21 snmp-agent usm-user
Syntax
snmp-agent usm-user { v1 | v2c } username groupname [ acl acl-list ]
undo snmp-agent usm-user { v1 | v2c } username groupname
snmp-agent usm-user v3 username groupname [ authentication-mode { md5 | sha }
authpassstring [ privacy-mode { des56 privpassstring } ] ] [ acl acl-list ]
undo snmp-agent usm-user v3 username groupname { local | engineid engine-id }
View
System view
To Next Page
Loading...
Need help?
General
