Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA & RADIUS Protocol Configuration Commands
Huawei Technologies Proprietary
3-7
state { active | block } Configures to display the local users in the specified state.
active means that the system allows the user requesting network service and block
means the system does not allow the user requesting network service.
user-name user-name : Configures to display a user specified with user-name .
user-name is the argument specifying the username. It is a character string not
exceeding 80 characters, excluding “/”, “:”, “*”, “?”, “<” and “>”. The @ character can
only be used once in one username. The pure username (the part before @, namely
the user ID) cannot exceed 55 characters.
vlan vlanid: Configures to display the users belonged to specified VLAN. vlanid is the
integer, ranging from 1 to 4094.
Description
Using display local-user command, you can view the relevant information of all the
local users or the specified one(s).
This command displays the relevant information about a specified or all the local users.
The output can help you with the fault diagnosis and troubleshooting related to local
user.
For the related command, see local-user.
Example
# Display the relevant information of all the local users.
<Quidway> display local-user
The contents of local user user1:
State: Active ServiceType Mask: T
Idle-cut: Disable
Access-limit: Disable Current AccessNum: 0
Bind location: Disable
Vlan ID: Disable
IP address: Disable
MAC address: Disable
User Privilege: 1
Total 1 local user(s) Matched, 1 listed.
Table 3-1 Output description of the display local-user command
Field Description
State The state of the user
Idle-Cut The state of the idle-cut switch
Access-Limit The limit to the number of access users.
Bind location Indicates whether the port is bound with or not
To Next Page
Loading...
Need help?
General
