Command Manual - Multicast
Quidway S3500 Series Ethernet Switches Chapter 2 IGMP Snooping Configuration Commands
Huawei Technologies Proprietary
2-8
Description
Using igmp-snooping host-aging-time command, you can configure the port aging
time of the multicast group members. Using undo igmp-snooping host-aging-time
command, you can restore the default value.
This command is used to set the aging time of the multicast group member so that the
refresh frequency can be controlled. When the group members change frequently, the
aging time should be comparatively short, and vice versa.
For the related command, see igmp-snooping.
Example
# Set the aging time to 300 seconds.
[Quidway] igmp-snooping host-aging-time 300
2.1.9 igmp-snooping max-response-time
Syntax
igmp-snooping max-response-time seconds
undo igmp-snooping max-response-time
View
System view
Parameter
seconds: Maximum response time for a query ranging from 1 to 100 and measured in
seconds; By default, 10.
Description
Using igmp-snooping max-response-time command, you can configure the
maximum response time for a query. Using undo igmp-snooping
max-response-time command, you can restore the default value.
The set maximum response time decides the time limit for the switch to respond to
IGMP Snooping general query packets.
For the related command, see igmp-snooping, igmp-snooping router-aging-time.
Example
# Configure to respond the IGMP Snooping packet within 50s.
[Quidway] igmp-snooping max-response-time 50
To Next Page
Loading...
Need help?
General
