Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-28
Table 3-15 Description of information generated by the command display ospf vlink
Field Description
Virtual-link
Neighbor-id
Router ID of virtual-link neighbor router
State State
Interface IP address the interface on the virtual link
Cost Route cost of the interface
Type Type: virtual link
Transit Area
ID of transit area that the virtual link passes, and it cannot be
backbone area, STUB area and NSSA area
OSPF timers, defining as follows:
Hello Interval of hello packet
Dead Interval of dead neighbors
Poll Interval of poll
Timers
Retransmit Interval of retransmitting LSA
Transmit Delay Delay time of transmitting LSA
3.1.26 filter-policy export
Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name } export [ routing-protocol ]
undo filter-policy { acl-number | ip-prefix ip-prefix-name} export [ routing-protocol ]
View
OSPF view
Parameter
acl-number: Access control list number.
ip-prefix-name: Name of the address prefix list.
routing-protocol: Protocol advertising the routing information, including direct, bgp, rip
and static at present.
Description
Using filter-policy export command, you can configure the rule of OSPF filtering the
advertised routing information. Using undo filter-policy export command, you can
cancel the filtering rules that have been set.
By default, no filtering of the distributed routing information is performed.
To Next Page
Loading...
Need help?
General
