Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-24
Field Description
Init
It indicates that OSPF router has received Hello packet from a neighbor
router, but its IP address is not contained in the Hello packet.
Therefore, a two-way communication between them has not been
established.
2-Way
It indicates that a two-way communication between OSPF router and
neighbor router has been established. DR and BDR can be selected in
this state (or higher state).
ExStart
In this state, the router determines the sequence number of initial
database description (DD) packet used for data exchange, so that it
can obtain the latest link state information
Exchange
It indicates that OSPF router sends DD packet to its neighbor routers to
exchange link state information
Loading
In this state, OSPF router requests neighbor routers based on the
updated link state information from neighbor routers and its expired
information, and waits for response from neighbor routers
Full
It indicates that database synchronization between the routers that
have established neighbor relation has been completed, and their link
state databases have been consistent
3.1.22 display ospf request-queue
Syntax
display ospf request-queue
View
Any view
Parameter
None
Description
Using display ospf request-queue command, you can view the information about the
OSPF request-queue.
Example
# Display the information of OSPF request-queue.
<Quidway> display ospf request-queue
The Router's Neighbors is
RouterID: 1.1.1.1 Address: 1.1.1.1
Interface: 1.1.1.3 Area: 0.0.0.0
LSID:1.1.1.3 AdvRouter:1.1.1.3 Sequence:80000017 Age:35
To Next Page
Loading...
Need help?
General
