Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-23
Neighbor has been up for 01:14:14
Table 3-10 Description of information generated by the command display ospf peer
Field Description
RouterID Router ID of neighbor router
Address
Address of the interface, through which neighbor router
communicates with the router
State State of adjacency relation
Mode
Master/Slave mode formed by negotiation in exchanging
DD packet
Priority Priority of DR/BDR for neighbor election
DR IP address of the interface of elected DR
BDR IP address of the interface of elected BDR
Dead timer expires in
31s
If no hello packet received from the peer within this
interval, the peer will be considered to be invalid.
Neighbor has been up
for 01:14:14
Time of neighbor connection
# View the brief information of every peer.
<Quidway> display ospf peer brief
Neighbor Statistics
Area ID Down Attempt Init 2-Way ExStart Exchange Loading Full Total
0.0.0.0 0 0 0 0 0 0 0 1 1
0.0.0.1 0 0 0 0 0 0 0 1 1
Total 0 0 0 0 0 0 0 2 2
Table 3-11 Description of information generated by the command display ospf peer
brief
Field Description
Area ID Area ID
Down
Initial state for OSPF to establish neighbor relation, which indicates that
OSPF router does not receive the message from a certain neighbor
router within a period of time
Attempt
It is enabled in NBMA environment, such as Frame Relay, X.25 or
ATM. It indicates that OSPF router does not receive the message from
a certain neighbor router within a period of time, but still attempts to
send Hello packet to the adjacent routers for their communications with
a lower frequency.
To Next Page
Loading...
Need help?
General
