Command Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 6 RMON Configuration Commands
Huawei Technologies Proprietary
6-9
Description
Using rmon alarm command, you can add an entry to the alarm table. Using undo
rmon alarm command, you can cancel an entry from this table.
In this way, the alarm event can be triggered in the abnormal situations and then
decides to log and send trap to the NM station.
Example
# Delete the information of entry 15 from the alarm table.
[Quidway] undo rmon alarm 15
6.1.8 rmon event
Syntax
rmon event event-entry [ description string ] { log | trap trap-community | log-trap
log-trapcommunity | None } [ owner rmon-station ]
undo rmon event event-entry
View
System view
Parameter
event-entry: Number of the entry to be added/deleted, ranging from 1 to 65535.
description string: Event description. Length of the character string ranges from 1 to
255.
log: Log event.
trap: Trap event.
trap-community: Name of the community that trap message is sent to.
log-trap: Log and trap event.
log-trapcommunity: Name of the community that trap message is sent to.
None: neither log nor trap event.
owner rmon-station: Name of the network management station that creates this entry.
The length of the character string ranges from 1 to 127.
Description
Using rmon event command, you can add an entry to the event table. Using undo
rmon event command, you can cancel an entry from this table.
Event management of RMON defines the way to deal with event number and event-log,
send trap message or log while sending trap message. In this way, alarm events may
obtain corresponding treatment
To Next Page
Loading...
Need help?
General
