Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-5
route-policy-name: Route policy name that filters routing information. After enabling
RIP protocol, you can determine which routes are to be sent/received based on
acl/cost/interface/ip/ip-prefix/tag fields.
Description
Using filter-policy gateway import command, you can configure to filter the received
routing information distributed from the specified address. Using undo filter-policy
gateway import command, you can configure not to filter the received routing
information distributed from the specified address.
Using filter-policy import command, you can configure the filtering to the received
global routing information. Using undo filter-policy import command, you can disable
filtering to the received global routing information
By default, RIP does not filter the received routing information.
For the related commands, see acl, filter-policy export, ip ip-prefix.
Example
# Configure the filtering of the global routing information according to acl 2000.
[Quidway-rip] filter-policy 2000 import
2.1.6 host-route
Syntax
host-route
undo host-route
View
RIP view
Parameter
None
Description
Using host-route command, you can control the RIP to accept the host route. Using
undo host-route command, you can reject the host route.
By default, RIP accepts the host route.
In some special cases, RIP receives a great number of host routes in the same network
segment. These routes cannot help the path searching much but occupy a lot of
resources. In this case, the undo host-route command can be used to reject a host
route.
To Next Page
Loading...
Need help?
General
