Command Manual - Reliability
Quidway S3500 Series Ethernet Switches Chapter 1 VRRP Configuration Commands
Huawei Technologies Proprietary
1-5
Due to the chips installed, some switches support matching one IP address to multiple
MAC addresses. Then you may configure correspondence between the virtual IP
address of the backup group and the real/virtual MAC address.
You should set correspondence between the virtual IP address of the backup group
and the MAC address before configuring the backup group. Otherwise, you cannot
configure the correspondence.
S3526, S3526 FM, S3526 FS Ethernet switches don’t support this command.
Example
# Set the real MAC address of the interface match the virtual IP address of the backup
group.
[Quidway] vrrp method real-mac
1.1.5 vrrp ping-enable
Syntax
vrrp ping-enable
undo vrrp ping-enable
View
System view
Parameter
None
Description
Using vrrp ping-enable command, you can enable the function to ping the virtual IP
address of the backup group. Using undo vrrp ping-enable command, you can
disable the function to pin the virtual IP address of the backup group.
By default, the ping function is disabled.
You can only use the commands before configuring the backup group.
Example
# Enable the function to ping the virtual IP address of the backup group.
[Quidway] vrrp ping-enable
1.1.6 vrrp vrid preempt-mode
Syntax
vrrp vrid virtual-router-ID preempt-mode [ timer delay delay-value ]
To Next Page
Loading...
Need help?
General
