Command Manual - Port
Quidway S3500 Series Ethernet Switches Chapter 2 Ethernet Port Link Aggregation Commands
Huawei Technologies Proprietary
2-2
Table 2-1 The description of link aggregation
Field Description
Master port Master port
Other sub-ports Other member ports
Mode Aggregation mode
2.1.2 link-aggregation
Syntax
link-aggregation port_num1 to port_num2 { both | ingress }
undo link-aggregation { master_port_num | all }
View
System view
Parameter
port_num1: Starting range value of Ethernet port joined the Ethernet link aggregation.
port_num2: Last range value of Ethernet port joined the Ethernet link aggregation.
both: Configures that the sub-ports in the link aggregation share outgoing load on the
port depending on the source address and destination MAC address.
ingress: Configures that the sub-ports in the link aggregation share outgoing load on
the port depending on the source MAC addresses.
master_port_num: Master port number in link aggregation.
all: all aggregated ports.
Description
Using link-aggregation command, you can configure a series of ports to aggregation
port and the port with the smallest port number as master port. Using undo
link-aggregation command, you can cancel the Ethernet link aggregation.
The link aggregation limit of Quidway S3552F, S3552G, S3552P, S3528G, S3528P
Ethernet swtich is that the 1000M port and 100M port can not be in the same
aggregation group.
For satisfactory payload balance effect, it is recommended that you configure the
Ethernet ports to be aggregated to operate at the same speed and with the same
duplex attribute.
For the related command, see display link-aggregation.
To Next Page
Loading...
Need help?
General
