Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-11
nonstandard: Specify the MD5 cipher text authentication packet to use a nonstandard
packet format described in RFC2082.
key-id: MD5 cipher text authentication identifier, ranging from 1 to 255.
key-string: MD5 authentication key. If it is input in a plain text form, MD5 key is a
character string not exceeding 16 characters. And it will be displayed in a cipher text
form in a length of 24 characters when display current-configuration command is
executed. Inputting the MD5 key in a cipher text form with 24 characters long is also
supported.
Description
Using rip authentication-mode command, you can configure RIP-2 authentication
mode and its parameters. Using undo rip authentication-mode command, you can
cancel the RIP-2 authentication.
RIP-1 does not support authentication. There are two RIP authentication modes:
simple authentication and MD5 cipher text authentication for RIP-2 . When MD5 cipher
text authentication mode is used, there are two types of packet formats. One of them is
that described in RFC 1723, which was brought forward earlier. The other format is the
one described specially in RFC 2082. The router supports both of the packet formats
and the user can select either of them on demands.
For the related commands, see rip version.
Example
# Specify Interface Vlan-interface 1 to use the simple authentication with the key as
aaa.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] rip version 2
[Quidway-Vlan-interface1] rip authentication-mode simple aaa
# Set MD5 authentication at Vlan-interface 1 with the key string as aaa and the packet
type as usual.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] rip version 2
[Quidway-Vlan-interface1] rip authentication-mode md5 usual aaa
2.1.14 rip input
Syntax
rip input
undo rip input
To Next Page
Loading...
Need help?
General
