Command Manual - Port
Quidway S3500 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-19
Parameter
vlan_id: VLAN ID defined in IEEE802.1Q, ranging from1 to 4094 and the default
vlan_id is 1.
Description
Using port trunk pvid vlan command, you can configure the default VLAN ID of trunk
port. Using undo port trunk pvid command, you can restore the default VLAN ID of
the port.
Trunk port and isolate-user-vlan cannot be configured simultaneously.
The default VLAN ID of local trunk port should be consistent with that of the peer one,
otherwise, the packet cannot be properly transmitted.
For the related command, see port link-type.
Example
# Configure the default VLAN of the trunk port Ethernet0/1 to 100.
[Quidway-Ethernet0/1] port trunk pvid vlan 100
1.1.24 reset counters interface
Syntax
reset counters interface [ interface_type | interface_type interface_num |
interface_name ]
View
User view
Parameter
interface_type: Specifies the port type.
interface_num: Specifies the port number.
interface_name: Specifies the port name in the interface_name= interface_type
interface_num format.
For parameter description, refer to the interface command.
Description
Using reset counters interface command, you can reset the statistical information on
the port. and count the related information again on the port for the user.
If the port type and number are not specified when clearing the port information,
information of all ports on the switch will be cleared. If only the port type is specified, all
the information on the ports of this type will be cleared. If both port type and port
number are specified, the information on the designated port will be cleared.
To Next Page
Loading...
Need help?
General
