Command Manual - VLAN
Quidway S3500 Series Ethernet Switches Chapter 1 VLAN Configuration Commands
Huawei Technologies Proprietary
1-6
Note that you can add/delete trunk port and hybrid port to/from VLAN by port and undo
port commands in Ethernet port view, but not in VLAN view.
For the related command, see display vlan.
Example
# Add Ethernet0/4 through Ethernet0/7, Ethernet0/9 and Ethernet0/11 through
Ethernet0/15 to VLAN 2. The repeated time of command parameter is 3 times.
[Quidway-vlan2] port ethernet0/4 to ethernet0/7 ethernet0/9 ethernet0/11 to
ethernet0/15
1.1.8 shutdown
Syntax
shutdown
undo shutdown
View
VLAN interface view
Parameter
None
Description
Using shutdown command, you can disable the VLAN interface. Using undo
shutdown command, you can enable the VLAN interface.
By default, when all Ethernet ports are in DOWN status in VLAN interface, the VLAN
interface is in DOWN status, i.e. disabled status. When there is one or more Ethernet
ports in VLAN interface are in UP status, the VLAN interface is UP.
This command can be used to start interface after the related parameters and protocols
of VLAN interface are set well. Or when the VLAN interface fails, the interface can be
shut down first and then restarted, in this way, the interface may be restored to normal
status. Shutting down or starting VLAN interface will not take any effect on any Ethernet
port of this VLAN.
Example
# Restart interface after shutting down the interface.
[Quidway-Vlan-interface1] shutdown
[Quidway-Vlan-interface1] undo shutdown
To Next Page
Loading...
Need help?
General
