Huawei quidway s3526 series

Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-13
Example
# Specify the additional route metric to 2 when the interface Vlan-interface 1 receives
RIP packets.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] rip metricin 2
2.1.16 rip metricout
Syntax
rip metricout value
undo rip metricout
View
Interface view
Parameter
value: Additional route metric added when transmitting a packet, ranging from 1 to 16.
By default, the value is 1.
Description
Using rip metricout command, you can configure the additional route metric to the
route when an interface transmits RIP packets. Using undo rip metricout command,
you can restore the default value of this additional route metric.
For the related commands, see rip metricin.
Example
# Set the additional route metric to 2 when the interface Vlan-interface 1 transmits RIP
packets.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] rip metricout 2
2.1.17 rip output
Syntax
rip output
undo rip output
View
Interface view