Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 4 BGP Configuration Commands
Huawei Technologies Proprietary
4-36
Parameter
group-name: Specify the name of the peer group.
peer-address: Specify the IP address of the peer.
list-number: Specify an IP acl number.
import: Ingress filter policy.
export: Egress filter policy.
Description
Using peer filter-policy command, you can configure the filter-policy list of a peer/peer
group. Using undo peer filter-policy command, you can cancel the existing
configuration.
By default, a peer/peer group has no access control list (ACL).
For the related commands, see acl.
Example
# Set the filter-policy list of a peer group test.
[Quidway-bgp] peer test filter-policy 2000 export
4.1.42 peer group
Syntax
peer peer-address group group-name
undo peer peer-address group group-name
View
BGP view
Parameter
group-name: Specify the name of the peer group.
peer-address: Specify the IP address of the peer.
Description
Using peer group command, you can add a peer to the peer group. Using undo peer
group command, you can delete the specified peer in the peer group.
The use of BGP peer group is for the convenience of the user’s configuration. When the
user starts several peers with the same configuration, a peer group can be established
first and be configured. Then add all the peers to the peer group so that they have the
same configuration as this peer group.
To Next Page
Loading...
Need help?
General
