Command Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 4 System Maintenance Commands
Huawei Technologies Proprietary
4-23
4.5.6 info-center logbuffer
Syntax
info-center logbuffer [ channel { channel-number | channel-name } ] [ size
buffersize ]
undo info-center logbuffer [ channel | size ]
View
System view
Parameter
channel: Configure the channel to output information to buffer.
channel-number: Channel number, ranging from 0 to 9, that is, system has ten
channels.
channel-name: Specify the channel name. The name can be channel6, channel7,
channel8, channel9, console, logbuffer, loghost, monitor, snmpagent,
trapbuffer.
size: Configure the size of buffer.
buffersize: Size of buffer (number of messages which can be kept); By default, the size
of the buffer is 20.
Description
Using info-center logbuffer command, you can configure to output information to the
memory buffer. Using undo info-center logbuffer command, you can cancel the
information output to buffer
This command takes effect only after the system logging is enabled.
For the related commands, see info-center enable, display info-center.
Example
# Send log information to buffer and sets the size of buffer as 50.
[Quidway] info-center logbuffer size 50
4.5.7 info-center loghost
Syntax
info-center loghost host-ip-addr [ channel { channel-number | channel-name } ]
[ facility local-number ] [ language { chinese | english } ]
undo info-center loghost host-ip-addr
To Next Page
Loading...
