Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 2 Portal Configuration Commands
Huawei Technologies Proprietary
2-6
undo portal
View
VLAN interface view
Parameter
server-name: Portal server name, in the range of 1 to 32 characters.
Description
Use the portal command to enable Portal authentication on a VLAN port.
Use the undo portal command to remove Portal authentication on a VLAN port.
If Portal is configured to operate in Layer 3 Portal authentication mode, you must
configure authentication network segments before the Portal authentication is enabled
on a VLAN port.
Before enabling Portal authentication on a VLAN port, you should assure the VLAN
interface is configured with a legal IP address, and the specified Portal server exists.
Example
# Enable Portal authentication on Vlan-interface 10. Specify a Portal server named
Quidway.
[Quidway-Vlan-interface10] portal Quidway
2.1.4 portal arp-handshake
Syntax
portal arp-handshake { interval interval | retry-times retry-times }*
undo portal arp-handshake { interval | retry-times }
View
System view
Parameter
interval: ARP handshake time interval, in the range of 10 to 180. The unit is second,
and the step length is 10. By default, it is 60 seconds.
retry-times: Maximum number of retries for ARP handshaking, in the range of 3 to 10.
By default, it is 5.
Description
Use the portal arp-handshake command to configure time interval and maximum
times of retries for ARP handshaking between a Portal switch and a host.
To Next Page
Loading...
Need help?
General
