Huawei quidway s3526 series User Manual

Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 1 Static Route Configuration Commands
Huawei Technologies Proprietary
1-10
Protocol: #DIRECT Preference: 0
*NextHop: 10.1.1.2 Interface: 10.1.1.2(Vlan-interface1)
Vlinkindex: 0
State: <Int ActiveU Retain Unicast>
Age: 3:23:44 Cost: 0/0
**Destination: 10.1.1.2 Mask: 255.255.255.255
Protocol: #DIRECT Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
Vlinkindex: 0
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Age: 3:23:44 Cost: 0/0
For detailed description of the output information, see Table 1-2.
1.1.6 display ip routing-table protocol
Syntax
display ip routing-table protocol protocol [ inactive | verbose ]
View
Any view
Parameter
inactive: With the parameter, this command displays the inactive route information.
Without the parameter, this command displays the active and inactive route
information.
verbose: With the verbose parameter, this command displays the verbose route
information. Without the parameter, this command displays the route summary.
protocol: the parameter has multiple selectable values:
z direct: Display direct connection route information
z static: Display the static route information.
z bgp: Display BGP route information.
z ospf: Display OSPF route information.
z ospf-ase: Display OSPF ASE route information.
z ospf-nssa: Display OSPF NSSA route information.
z rip: Display RIP route information.
Description
Using display ip routing-table protocol command, you can view the route information
of specified protocol.

Huawei quidway s3526 series Specifications

General

Brand	Huawei
Model	quidway s3526 series
Category	Network Router
Language	English