Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-3
<Quidway> display rip
RIP is turned on
public net VPN-Instance
Checkzero is on Default cost : 1
Summary is on Preference : 100
No peer router
Network :
10.0.0.0
Table 2-1 Description of information generated by the command display rip
Field Description
RIP is turned on RIP is active
Checkzero is on Enable zero field checking
Default cost : 1 The default route cost is 1
Summary is on Routes are summarized automatically
Preference : 100 The preference of RIP is 100
No peer router No destination address of a transmission is specified
Network : 10.0.0.0 Enable RIP on network segment 10.0.0.0
2.1.4 filter-policy export
Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name | route-policy route-policy-name }
export [ routing-protocol ]
undo filter-policy { acl-number | ip-prefix ip-prefix-name | route-policy
route-policy-name } export [ routing-protocol ]
View
RIP view
Parameter
acl-number: Access control list number used for filtering the destination addresses of
the routing information.
ip-prefix-name: Name of address prefix list used for filtering the destination addresses
of the routing information.
route-policy-name: Route policy name that filters routing information. After enabling
RIP protocol, you can determine which routes are to be sent/received based on
acl/cost/interface/ip/ip-prefix/tag fields.
To Next Page
Loading...
Need help?
General
