Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 2 Portal Configuration Commands
Huawei Technologies Proprietary
2-9
Example
# Configure IP address 10.1.1.0 as a free IP address.
[Quidway] portal free-ip 10.1.1.0
2.1.8 portal free-user
Syntax
portal free-user mac mac-address ip ip-address vlan vlan_id interface
{ interface_type interface_num | interface_name }
undo portal free-user { mac mac-address | all }
View
System view
Parameter
mac mac-address: MAC address for the authentication-free user.
ip ip-address: IP address for the authentication-free user. The IP address cannot be
0.0.0.0, loopback address, multicast address or broadcast address.
vlan vlan_id: VLAN for the authentication-free user, in the range of 1 to 4,094.
interface: Port of the switch where an authentication-free user locates. This port
should be in the VLAN specified by this command.
interface_type: Port type. Its value is Ethernet or GigabitEthernet.
interface_num: Port number. The port is numbered in slot/port format.
interface_name: Port name expressed in interface_name=interface_type
interface_num.
all: Deletes all the authentication-free users.
Description
Use the portal free-user command to configure Portal authentication-free users.
Use the undo portal free-user command, you can delete the specified or all
authentication-free users.
When networking, you can configure network devices connected to the switch and
some servers as authentication-free users. These devices can access all networks
without authentication.
Authentication-free user information contains the IP address, MAC address, connected
switch port, and VLAN. The user whose information matches all the authentication-free
user information is allowed to access the Internet without authentication.
To Next Page
Loading...
Need help?
General
