Command Manual - Multicast
Quidway S3500 Series Ethernet Switches Chapter 5 PIM Configuration Commands
Huawei Technologies Proprietary
5-12
5.1.15 pim timer hello
Syntax
pim timer hello seconds
undo pim timer hello
View
Interface view
Parameter
seconds: Interval of sending Hello messages in second ranging from 1 to 18000. By
default, the interval value is 30 seconds.
Description
Using pim timer hello command, you can configure the interval of sending PIM router
Hello messages. Using undo pim timer hello command, you can restore the default
value.
Example
# Configure to transmit Hello packet via VLAN-interface10 every 40 seconds.
[Quidway-Vlan-interface10] pim timer hello 40
5.1.16 register-policy
Syntax
register-policy acl-number
undo register-policy
View
PIM view
Parameter
acl-number: Number of IP advanced ACL, defining the rule of filtering the source and
group addresses. The value ranges from 3000 to 3999.
Description
Using register-policy command, you can configure a RP to filter the register
messages sent by the DR in the PIM-SM network and to accept the specified
messages only. Using undo register-policy command, you can remove the
configured message filtering.
To Next Page
Loading...
Need help?
General
