Command Manual - Getting Started
Quidway S3500 Series Ethernet Switches Chapter 1 Logging in Switch Commands
Huawei Technologies Proprietary
1-15
Parameter
screen-length: Specifies how many lines can be displayed on a screen, ranging from 0
to 512. The default value is 24.
Description
Using screen-length command, you can configure how many lines that can be
displayed on a screen of the terminal. Using undo screen-length command, you can
restore the default number of terminal information lines displayed on the terminal
screen.
The screen-length 0 command is used to disable this function.
Example
# Configure the lines that can be displayed on a screen as 20 lines.
[Quidway-ui-aux0] screen-length 20
1.1.20 send
Syntax
send { all | number | type number }
View
User view
Parameter
all: Configures to send message to all user interfaces.
type: Specifies the user interface type, which can be aux or vty.
number: Specifies the absolute/relative number of the user interface.
Description
Using send command, you can send messages between different user interfaces.
Example
# Send message to all the user interfaces.
<Quidway> send all
1.1.21 service-type
Syntax
For S3552 series, S3528 series, S3526E series and S3526C:
To Next Page
Loading...
Need help?
General
