Command Manual - STP
Quidway S3500 Series Ethernet Switches Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-19
disable: Configure the current port as a non-edge port.
Description
Using stp interface edged-port enable command, you can configure a port as an
edge port in system view. Using stp interface edged-port disable command, you can
configure a port as a non-edge port in system view. Using undo stp interface
edged-port command, you can restore the non-edge port, as defaulted.
By default, all the switch ports are configured as non-edge port.
If the current Ethernet port is connected to other switch, you can use the stp interface
edged-port disable or no stp interface edged-port command to configure it as a
non-edge port. The stp interface edged-port enable command is used for configuring
the port as an edge port.
A port is considered as an edge port when it is directly connected to the user terminal,
instead of any other switches or shared network segments. The edge port will not
cause loop upon network topology changes. Accordingly, you can configure a port as
an edge port, so that it can transit to forwarding state fast. For this purpose, please
configure the Ethernet port directly connected to the user terminal as an edge port.
Because the edge port is not connected to any other switches, it will not receive the
configuration BPDUs from them. Before BPDU PROTECTION is enabled on the switch,
the port received a BPDU runs as a non-edge port, even if it is configured as edge port.
For the related command, see stp edged-port.
Example
# Configure Ethernet 0/3 as an edge port in system view.
[Quidway] stp interface ethernet 0/3 edged-port enable
1.1.20 stp interface cost
Syntax
stp interface interface-list [ instance instance-id ] cost cost
undo stp interface interface-list [ instance instance-id ] cost
View
System view
Parameter
interface-list: Ethernet port list, containing multiple Ethernet ports and expressed as
interface _list = { { interface_type interface_num | interface_name } [ to { interface_type
interface_num | interface_name } ] }&<1-10>. For detail descriptions of interface_type,
interface_num and interface_name parameters, refer to the corresponding descriptions
To Next Page
Loading...
Need help?
General
