Command Manual - Getting Started
Quidway S3500 Series Ethernet Switches Chapter 1 Logging in Switch Commands
Huawei Technologies Proprietary
1-24
Parameter
type: Specifies the user interface type, which can be aux or vty.
first-number: Specifies the number of the first user interface to be configured.
last-number: Specifies the number of the last user interface to be configured.
Description
Using user-interface command, you can enter single user interface view or multiple
user interface views to configure the corresponding user interfaces.
Example
# Enter user interface view 0 through 5, that is, 1 AUX (Console) port user interface
view and 5 VTY user interface views.
[Quidway] user-interface 0 5
[Quidway-ui0-5]
1.1.32 user privilege level
Syntax
user privilege level level
undo user privilege level
View
User interface view
Parameter
level: Specifies which level of command a user can use after logon from the specifically
user interface, ranging from 0 to 3.
Description
Using user privilege level command, you can configure which level of command a
user can use after logon from the specifically user interface, so that a user can use all
the available commands at this level. Using undo user privilege level command, you
can restore the default level of command a user can use after logon from the
specifically user interface.
By default, a user can access the commands at Level 3 after logging in through the
AUX user interface, and the commands at Level 0 after logging in through the VTY user
interface.
Example
# Configure to use commands level 0 after logging in from VTY 0 user interface.
To Next Page
Loading...
Need help?
General
