Command Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches Chapter 2 QoS Commands
Huawei Technologies Proprietary
2-25
For the related command, see queue-scheduler.
Example
# Display the queue scheduling mode and parameters.
<Quidway> display queue-scheduler
Queue scheduling mode: strict-priority
The display information shows the queue scheduling mode of the switch is
Strict-Priority.
2.2.11 line-rate
Syntax
line-rate target-rate
undo line-rate
View
Ethernet port view
Parameter
target-rate: Specifies the general packet sending rate on a port, ranging from 1 to 100
measured in Mbps.
Description
Using line-rate command, you can configure the limitation of the rate to restrict the
general speed of sending packets through the port. Using undo line-rate command,
you can cancel the limitation of the rate.
This command is used for configuring the general limitation of rate on the port for
sending packets.
Example
# Limit the rate on port e0/1 to 10Mbps.
[Quidway-Ethernet0/1] line-rate 10
2.2.12 mirrored-to
Syntax
mirrored-to { user-group acl-number | acl-name [ rule rule ] | { ip-group { acl-number
| acl-name } [ rule rule ] | link-group { acl-number | acl-name } [ rule rule ] }* } interface
{ interface-name | interface-type interface-num }
To Next Page
Loading...
Need help?
General
