Command Manual - Multicast
Quidway S3500 Series Ethernet Switches Chapter 4 IGMP Configuration Commands
Huawei Technologies Proprietary
4-9
Example
# Set querier to expire after 300 seconds.
[Quidway-Vlan-interface10] igmp timer other-querier-present 300
4.1.11 igmp timer query
Syntax
igmp timer query seconds
undo igmp timer query
View
Interface view
Parameter
seconds: Interval at which a router transmits IGMP query messages in second in the
range from 1 to 65535. By default, the value is 60 seconds.
Description
Using igmp timer query command, you can configure the interval at which a router
interface sends IGMP query messages. Using undo igmp timer query command, you
can restore the default value.
A multicast router periodically sends out IGMP query messages to attached segments
to find hosts that belong to different multicast groups. The query interval can be
modified according to the practical conditions of the network.
For the related command, see igmp timer other-querier-present.
Example
# Configure to transmit the host-query message every 60 seconds via
VLAN-interface2.
[Quidway-Vlan-interface2] igmp timer query 60
4.1.12 igmp version
Syntax
igmp version { 1 | 2 }
undo igmp version
View
Interface view
To Next Page
Loading...
Need help?
General
