Command Manual - Port
Quidway S3500 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-6
<Quidway> display loopback-detection
Loopback-detection is running
Detection interval time is 30 seconds
There is no port existing loopback link
Table 1-2 Output description of the display loopback-detection command
Field Description
Loopback-detection is running The loopback detection is enabled
Detection interval time is 30 seconds The detection interval is 30 seconds
There is no port existing loopback link No port is in the loopback state
1.1.5 display port
Syntax
display port { hybrid | trunk }
View
Any view
Parameter
hybrid: Display Hybrid port.
Trunk: Display Trunk port.
Description
Using display port command, you can view the ports in the current system, whose link
type is Hybrid or Trunk. If there is any such port, display the corresponding port name.
Example
# Display the Hybrid ports in the current system.
<Quidway> display port hybrid
Now, the following hybrid ports exist:
Ethernet0/1 Ethernet0/2
The above information displays that the current system has two Hybrid ports,
Ethernet0/1 and Ethernet0/2.
1.1.6 duplex
Syntax
duplex { auto | full | half }
To Next Page
Loading...
Need help?
General
