Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA & RADIUS Protocol Configuration Commands
Huawei Technologies Proprietary
3-25
user-name user-name: Configures to display the saved stopping accounting requests
according to the username. User-name specifies the username, a character string not
exceeding 80 characters.
Description
Using display stop-accounting-buffer command, you can view the stopping
accounting requests, which have not been responded and saved in the buffer.
After transmitting the stopping accounting requests, if there is no response from the
RADIUS server, the switch will save the packet in the buffer and retransmit it for several
times, which is set through the retry realtime-accounting command.
This command is used to display the stopping accounting requests saved in the switch
buffer. You can select to display the packets sent to a certain RADIUS server, or display
the packets according to user session ID or username. You may also display the
request packets saved during a specified time range. The displayed packet information
can help with diagnosis and troubleshooting.
For the related commands, see reset stop-accounting-buffer,
stop-accounting-buffer enable, retry stop-accounting.
Example
# Display the stopping accounting requests saved in the system buffer since 0:0:0 to
23:59:59 on August 31, 2002.
<Quidway> display stop-accounting-buffer time-range 0:0:0-2002/08/31
23:59:59-2002/08/31
Total find 0 record
3.2.8 key
Syntax
key { accounting | authentication } string
undo key { accounting | authentication }
View
RADIUS scheme view
Parameter
accounting: Configures to set/delete the encryption key for RADIUS accounting
packet.
authentication: Configures to set/delete the encryption key for RADIUS
authentication/authorization packet.
string: Specifies the key with a character string not exceeding 16 characters. By default,
the key is “huawei”.
To Next Page
Loading...
Need help?
General
