Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA & RADIUS Protocol Configuration Commands
Huawei Technologies Proprietary
3-10
the idle-cut is configured to enable or disable by neither the user nor the RADIUS
server, the user will adopt the idle-cut state in the template.
Because a user template only works in one ISP domain, it is necessary to configure
user template attributes for users from different ISP domain respectively.
For the related command, see domain
Example
# Enable the user in the current ISP domain, huawei163.net, to use the idle-cut attribute
specified in the user template (that is, enabling the user to use the idle-cut function).
The maximum idle time is 50 minutes and the minimum data traffic is 500 bytes.
[Quidway-isp-huawei163.net] idle-cut enable 50 500
3.1.9 local-user
Syntax
local-user user-name
undo local-user { user-name | all [ service-type { telnet | ftp | lan-access | ssh } ] }
View
System view
Parameter
user-name: Specifies a local username with a character string not exceeding 80
characters, excluding “/”, “:”, “*”, “?”, “<” and “>”. The @ character can only be used
once in one username. The pure username (the part before @, namely the user ID)
cannot exceed 55 characters. The user-name is case-insensitive, so that UserA is the
same as usera.
service-type: Specifies the service type. telnet means that: the specified user type is
telnet. ftp means that: the specified user type is ftp. lan-access means that the
specified user type is lan-access which mainly refers to Ethernet accessing users,
802.1x supplicants for example. ssh means the specified user type is SSH. (S3526,
S3526 FM and S3526 FS switches don’t support SSH.)
all: All the users.
Description
Using local-user command, you can configure a local user and enter the local user
view. Using undo local-user command, you can cancel a specified local user.
By default, no local user.
For the related commands, see display local-user , service-type.
To Next Page
Loading...
Need help?
General
