Command Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 7 NTP Configuration Commands
Huawei Technologies Proprietary
7-12
Parameter
number: Specify the key number, ranging from 1 to 4294967295.
Description
Using ntp-service reliable authentication-keyid command, you can configure the
key as reliable. Using undo ntp-service reliable authentication-keyid command,
you can cancel the current setting.
By default, no key is configured as reliable.
When you enable the authentication, you can use this command to configure one or
more than one keys as reliable. In this case, a client will only get synchronized by a
server whichever can provide a reliable key.
Example
# Enable NTP authentication, adopt MD5 encryption, and designate Key 37 BetterKey
and configure it as reliable.
[Quidway] ntp-service authentication enable
[Quidway] ntp-service authentication-keyid 37 authentication-mode md5
BetterKey
[Quidway] ntp-service reliable authentication-keyid 37
7.1.16 ntp-service source-interface
Syntax
ntp-service source-interface { interface-name | interface-type interface-number }
undo ntp-service source-interface
View
System view
Parameter
interface-name: Specify an interface. The source IP address of the packets will be
taken from the address of the interface.
interface-type: Specify the interface type and determine an interface with the
interface-number parameter.
interface-number: Specify the interface number and determine an interface with the
interface-type parameter.
To Next Page
Loading...
Need help?
General
