Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA & RADIUS Protocol Configuration Commands
Huawei Technologies Proprietary
3-39
active: Configures the RADIUS server to be active, namely the normal operation state.
Description
Using state command, you can configure the state of RADIUS server.
By default, all the RADIUS servers in every RADIUS scheme are in the state of block.
For the primary and second servers (no matter an authentication/authorization or an
accounting server), if the primary server is disconnected to NAS for some fault, NAS
will automatically turn to exchange packets with the second server. However, after the
primary one recovers, NAS will not resume the communication with it at once, instead,
it continues communicating with the second one. When the second one fails to
communicate, NAS will turn to the primary one again. This command is used to set the
primary server to be active manually, in order that NAS can communicate with it right
after the troubleshooting.
When the primary and second servers are all active or block, NAS will send the
packets to the primary server only.
For the related commands, see radius scheme, primary authentication, secondary
authentication, primary accounting, secondary accounting.
Example
# Set the second authentication server of RADIUS scheme, “huawei”, to be active.
[Quidway-radius-huawei] state secondary authentication active
3.2.24 stop-accounting-buffer enable
Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
View
RADIUS scheme view
Parameter
None
Description
Using stop-accounting-buffer enable command, you can configure to save the
stopping accounting requests without response in the switch system buffer. Using
undo stop-accounting-buffer enable command, you can cancel the function of
saving the stopping accounting requests without response in the switch system buffer.
By default, enable to save the stopping accounting requests in the buffer.
To Next Page
Loading...
Need help?
General
