Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 1 802.1x Configuration Commands
Huawei Technologies Proprietary
1-14
Note that when performing this function, the user logging on via proxy need to run
Huawei 802.1x client program,( Huawei 802.1x client program version V1.29 or above
is needed).
This command is used to set on the specified interface when executed in system view.
The parameter interface-list cannot be input when the command is executed in
Ethernet Port view and it has effect only on the current interface. After globally enabling
proxy user detection and control in system view, only if you enable this feature on a
specific port can this configuration take effects on the port.
For the related command, see display dot1x.
Example
# Configure the switch cut network connection to a user upon detecting the use of proxy
on Ethernet 0/1 ~ Ethernet 0/8.
[Quidway] dot1x supp-proxy-check logoff
[Quidway] dot1x supp-proxy-check logoff interface Ethernet 0/1 to Ethernet 0/8
# Configure the switch to send trap message upon detecting the use of proxy on
Ethernet 0/9.
[Quidway] dot1x supp-proxy-check trap
[Quidway] dot1x supp-proxy-check trap interface Ethernet 0/9
or
[Quidway] dot1x supp-proxy-check trap
[Quidway] interface Ethernet 0/9
[Quidway-Ethernet0/9] dot1x supp-proxy-check trap
1.1.14 dot1x timer
Syntax
dot1x timer { handshake-period handshake-period-value | quiet-period
quiet-period-value | reauth-period reauth-period-value | server-timeout
server-timeout-value | supp-timeout supp-timeout-value | tx-period tx-period-value |
ver-period ver-period-value }
undo dot1x timer { handshake-period | quiet-period | reauth-period |
server-timeout | supp-timeout | tx-period | ver-period }
View
System view
Parameter
handshake-period: This timer begins after the user has passed the authentication.
After setting handshake-period, system will send the handshake packet by the period.
To Next Page
Loading...
Need help?
General
