Command Manual - Auto Detecting
Quidway S3500 Series Ethernet Switches Chapter 2 Auto Detect Implementation Commands
Huawei Technologies Proprietary
2-2
the next hop. In addition, the system discards any IP packet transmitted along this route
without informing the source.
group-number: Specifies the number of the detecting group, which ranges from 1 to
100.
Description
Use the ip route-static command to configure a static route, whose validity depends
on detecting results as follows:
z Valid when the detecting result is reachable.
z Invalid when the detecting result is unreachable.
Use the undo ip route-static command to remove an existing static route.
Example
# Configure a static route to 192.168.0.5/24 with 192.168.0.2 as the next hop. The
route is to be enabled when the result of detecting group 10 is reachable.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] ip route-static 192.168.0.5 24 192.168.0.2 detect-group 10
2.1.2 standby detect-group
Syntax
standby detect-group group-number
undo standby detect-group group-number
View
VLAN interface views
Parameter
group-number: Specifies the detecting group number, which ranges from 1 to 100.
Description
Use the standby detect-group command to specify to enable VLAN interface backup
function by using the auto detect function.
Use the undo standby detect-group command to disable VLAN interface backup
function.
You can enable VLAN interface backup function by auto detecting results in the
following ways:
z Enable the primary interface when the result of the detecting group is reachable.
To Next Page
Loading...
Need help?
General
