Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA & RADIUS Protocol Configuration Commands
Huawei Technologies Proprietary
3-36
Example
# Indicate that, when stopping accounting request for the RADIUS scheme “Huawei”,
the switch will retransmit the packets for up to 1000 times.
[Quidway-radius-huawei] retry stop-accounting 1000
3.2.20 secondary accounting
Syntax
secondary accounting ip-address [ port-number ]
undo secondary accounting
View
RADIUS scheme view
Parameter
ip-address: IP address, in dotted decimal format. By default, the IP addresses of
second accounting server is at 0.0.0.0.
port-number: Specifies the UDP port number, ranging from 1 to 65535. By default, the
accounting service is provided via UDP 1813.
Description
Using secondary accounting command, you can configure the IP address and port
number for the second RADIUS accounting server. Using undo secondary
accounting command, you can restore the IP address and port number to default
values.
For detailed information, read the Description of the primary accounting command.
For the related commands, see key, radius scheme, state.
Example
# Set the IP address of the second accounting server of RADIUS scheme, huawei, to
10.110.1.1 and the UDP port 1813 to provide RADIUS accounting service.
[Quidway-radius-huawei] secondary accounting 10.110.1.1 1813
3.2.21 secondary authentication
Syntax
secondary authentication ip-address [ port-number ]
undo secondary authentication
To Next Page
Loading...
Need help?
General
