Command Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches Chapter 2 QoS Commands
Huawei Technologies Proprietary
2-12
2.1.12 reset traffic-statistic
Syntax
reset traffic-statistic { all | ip-group { acl-number | acl-name } [ rule rule ] |
link-group { acl-number | acl-name } [ rule rule ] }
View
User view
Parameter
all: Indicates to clear all the traffic statistics information of the ACLs configured with this
function (including the combination items).
ip-group { acl-number | acl-name } [ rule rule ]: Specifies a basic or advanced ACL.
acl-number: Specifies the ACL sequence number, ranging from 2000 to 3999. acl-name:
Specifies the ACL name with a character string starting with English letters ([a-z, A-Z])
and excluding space and quotation mark. rule rule: Specifies a rule of an ACL, ranging
from 0 to 127. If you do not set this parameter, all the rules will be considered.
link-group { acl-number | acl-name } [ rule rule ]: Specifies a Layer-2 ACL. acl-number:
Specifies the ACL sequence number, ranging from 4000 to 4999, acl-name: Specifies
the ACL name with a character string starting with English letters ([a-z, A-Z]) and
excluding space and quotation mark. rule rule: Specifies a rule of an ACL, ranging from
0 to 127. If you do not set this parameter, all the rules will be considered.
Description
Using reset traffic-statistic command, you can reset the traffic statistics information.
This command is used for clearing the statistics information about all the traffic or a
specified one.
Table 2-7 The comparison between reset commands of statistics information
Command Function
reset acl counter
Reset the statistics information of the ACL which is used in the
case of filtering or classifying the data treated by the software
of switch. The case includes: ACL cited by route policy
function, ACL used for control logon user, etc. The ACL
number ranges from 2000 to 3999.
reset
traffic-statistic
Reset statistic information of traffic. This command is used in
the case of filtering or classifying the data transmitted by the
hardware of switch. Commonly, this command is used to reset
the statistics information of the traffic-statistic command.
To Next Page
Loading...
Need help?
General
