Huawei quidway s3526 series

Command Manual - Multicast
Quidway S3500 Series Ethernet Switches Chapter 3 Multicast Common Configuration Commands
Huawei Technologies Proprietary
3-4
Field Description
iif Vlan-interface1, 1 oifs
Multicast forwarding cache table has an
incoming interface Vlan-interface 1 and one
outgoing interface
List of outgoing interface:
01: Vlan-interface2
List of outgoing interface has an outgoing
interface Vlan-interface 2
Matched 236 pkts(3267 bytes),
Wrong If 0 pkts
Forwarded 233 pkts(3267
bytes)
236 matched packets (3267 bytes); 0
matched packets means wrong; 233
forwarded packets (3267 bytes)
Matched 2 entries 2 matched entries
3.1.5 display multicast routing-table
Syntax
display multicast routing-table [ group-address [ mask { mask | mask-length } ] |
source-address [ mask { mask | mask-length } ] | incoming-interface { interface-type
interface-number | register } ]*
View
Any view
Parameter
group-address: Multicast group address, used to specify a multicast group and display
the corresponding routing table information of the group. The value ranges from
224.0.0.0 to 239.255.255.255.
source-address: Unicast IP address of the multicast source.
incoming-interface: Incoming interface of the multicast route entry.
interface-type interface-number: Specifies the interface.
register: Register interface of PIM-SM.
Description
Using display multicast routing-table command, you can view the information of IP
multicast routing table.
This command displays the multicast routing table information, while the display
multicast forwarding-table command displays the multicast forwarding table
information.