Command Manual - Multicast
Quidway S3500 Series Ethernet Switches Chapter 4 IGMP Configuration Commands
Huawei Technologies Proprietary
4-8
Description
Using igmp max-response-time command, you can configure the maximum response
time contained in the IGMP query messages. Using undo igmp max-response-time
command, you can restore the default value.
The maximum query response time determines the period for a router to quickly detect
that there are no more directly connected group members in a LAN.
For the related command, see display igmp group.
Example
# Set the maximum response time carried in host-query message to 8 seconds.
[Quidway-Vlan-interface10] igmp max-response-time 8
4.1.10 igmp timer other-querier-present
Syntax
igmp timer other-querier-present seconds
undo igmp timer other-querier-present
View
Interface view
Parameter
seconds: IGMP querier present timer value in second ranging from 60 to 300. By
default, the value is twice the value of IGMP query message interval, i.e., 120 seconds.
Description
Using igmp timer other-querier-present command, you can configure the timer of
presence of the IGMP querier. Using undo igmp timer other-querier-present
command, you can restore the default value.
On a shared network, i.e., there are multiple multicast routers on the same network
segment, the query router (querier for short) takes charge of sending query messages
periodically on the interface. If other non-queriers receive no query messages within
the valid period, the router will consider the previous query to be invalid and the router
itself becomes a querier.
In IGMP version 1, the selection of a query is determined by the multicast routing
protocol. In IGMP version 2, the router with the lowest IP address on the shared
network segment acts as the querier.
For the related commands, see igmp timer query and display igmp interface.
To Next Page
Loading...
