Command Manual - Getting Started
Quidway S3500 Series Ethernet Switches Chapter 1 Logging in Switch Commands
Huawei Technologies Proprietary
1-18
Description
Using set authentication password command, you can configure the password for
local authentication. Using undo set authentication password command, you can
cancel local authentication password.
The password in plain text is required when performing authentication, regardless
whether the configuration is plain text or encrypted text.
Note:
By default, password is required to be set for authenticating the users connecting via
Modem or Telnet. If no password has been set, the following prompt will be displayed
“Login password has not been set !”
Example
# Configure the local authentication password on VTY 0 to huawei.
[Quidway-ui-vty0] set authentication password simple huawei
1.1.23 shell
Syntax
shell
undo shell
View
User interface view
Parameter
None
Description
Using shell command, you can enable terminal service of a user interface. Using undo
shell command, you can disable the terminal service of a user interface.
By default, terminal service is enabled.
When using the undo shell command, note the following points.
z For the sake of security, the undo shell command can only be used on the user
interfaces other than the AUX user interface.
z You cannot use this command on the user interface via which you log in.
To Next Page
Loading...
Need help?
General
