Command Manual - Auto Detecting
Quidway S3500 Series Ethernet Switches Chapter 1 Auto Detect Configuration Commands
Huawei Technologies Proprietary
1-5
1.1.5 retry
Syntax
retry retry_times
View
Detecting group views
Parameter
retry_times: Specifies the retry times during a detection, which ranges from 0 to 10 and
defaults to 2.
Description
Use the retry command to set the retry times during a detection.
Example
# Specify the maximum retires to 10 for detecting group 10.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] detect-group 10
[Quidway-detect-group-10] retry 3
1.1.6 timer loop
Syntax
timer loop seconds
View
Detecting group views
Parameter
seconds: Specifies the detecting interval, which ranges form 5 to 86400 (in seconds)
and defaults to 15.
Description
Use the timer loop command to set the detecting interval, that is, the frequency to
perform auto detect.
Example
# Set the detecting interval of detecting group 10 to 60 seconds.
<Quidway> system-view
To Next Page
Loading...
