Command Manual - Getting Started
Quidway S3500 Series Ethernet Switches Chapter 1 Logging in Switch Commands
Huawei Technologies Proprietary
1-17
Commands of this level involve file system commands, FTP commands, TFTP
commands, XModem downloading commands, user management commands,
and level setting commands.
Example
# Configure the user zbr to use commands at level 0 after logon.
[Quidway] local-user zbr
[Quidway-luser-zbr] service-type telnet level 0
# Quit the system and logs on with username “zbr” again. Now only the commands at
level 0 are listed on the terminal.
[Quidway] quit
<Quidway> ?
User view commands:
cluster Run cluster command
language-mode Specify the language environment
ping Ping function
quit Exit from current command view
super Privilege specified user priority level
telnet Establish one TELNET connection
tracert Trace route function
1.1.22 set authentication password
Syntax
set authentication password { cipher | simple } password
undo set authentication password
View
User interface view
Parameter
cipher: Configure encrypted text password.
simple: Configure plain text password.
password: If the authentication is in the simple mode, the password must be in plain
text. If the authentication is in the cipher mode, the password can be either in
encrypted text or in plain text. The result is determined by the input. A plain text
password is a sequential character string of no more than 16 digits, for example,
huawei918. The length of an encrypted password must be 24 digits and in encrypted
text, for example, _(TT8F]Y\5SQ=^Q`MAF4<1!!.
To Next Page
Loading...
Need help?
General
