Command Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 6 DHCP Configuration Commands
Huawei Technologies Proprietary
6-12
View
System view
Parameter
packets number: The maximum number of ping packets allowed to be sent, which is in
the range of 0 (no ping attempt) to 10 and defaults to 2.
timeout milliseconds: The longest time period that the DHCP server waits for the
response to each ping packet, which is in the range of 0 to 10000 milliseconds and
defaults to 500 milliseconds.
Description
Using the dhcp server ping command, you can configure the maximum number of
ping packets that the DHCP server is allowed to send and the longest time period that it
waits for the response to each ping. Using the undo dhcp server ping command, you
can restore the default settings.
Example
# Allow the DHCP server to send up to ten ping packets and wait 500 milliseconds
(default) for the response to each ping.
[Quidway] dhcp server ping packets 10
6.2.11 dhcp server static-bind
Syntax
dhcp server static-bind ip-address ip-address mac-address mac-address
undo dhcp server static-bind { ip-address ip-address | mac-address mac-address }
View
VLAN interface view
Parameter
ip-address: IP address in a static binding, a valid IP address selected from the address
pool on the current VLAN interface.
mac-address: MAC address in a static binding.
Description
Using the dhcp server static-bind command, you can configure a static address
binding in the DHCP address pool on the current VLAN interface. Using the undo dhcp
server static-bind command, you can remove the binding.
By default, no static address binding is configured in any VLAN interface address pool.
To Next Page
Loading...
Need help?
General
