Command Manual - VLAN
Quidway S3500 Series Ethernet Switches Chapter 1 VLAN Configuration Commands
Huawei Technologies Proprietary
1-2
Description
Using display interface vlan-interface command, you can view the related
information about specified or all VLAN interfaces such as physical status and link
status of VLAN interface, Ethernet frame format, MAC address, IP address and sub-net
mask, description character string and MTU, etc.
With vlan_id specified, only the information about the specified VLAN interface will be
displayed. If no vlan_id is specified, the information about all the existing VLAN
interfaces will be displayed.
For the related command, see interface vlan-interface.
Example
# Display related information about VLAN-interface 1.
<Quidway> display interface vlan-interface 1
Vlan-interface1 current state : DOWN
Line protocol current state : DOWN
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is
00e0-fc07-4101
Internet Address is 10.1.1.1/24 Primary
Description : Vlan-interface1 Interface
The Maximum Transmit Unit is 1500
1.1.3 display vlan
Syntax
display vlan [ vlan_id | all | static | dynamic ]
View
Any view
Parameter
vlan_id: Display information of specified VLAN.
all: Display information of all VLANs.
static: Display information of VLAN created statically by the system.
dynamic: Display information of VLAN created dynamically by the system.
Description
Using display vlan command, you can view related information about the specified or
all VLANs.
If vlan_id or all is specified, information of specified VLAN or all VLANs is displayed. It
includes: VLAN ID, VLAN state, whether the routing function has been enable on this
To Next Page
Loading...
Need help?
General
