Command Manual - Multicast
Quidway S3500 Series Ethernet Switches Chapter 5 PIM Configuration Commands
Huawei Technologies Proprietary
5-14
5.1.18 static-rp
Syntax
static-rp rp-address [ acl-number ]
undo static-rp
View
PIM view
Parameter
rp-address: Static RP address, only being legal unicast IP address.
acl-number: Basic ACL, used to control the range of multicast group served by static RP,
which ranges from 2000 to 2999. If an ACL is not specified upon configuration, static
RP will serve all multicast groups; if an ACL is specified, static RP will only serve the
multicast group passing the ACL.
Description
Using static-rp command, you can configure static RP. Using undo static-rp
command, you can remove the configuration.
Static RP functions as the backup of dynamic RP so as to improve the network
robusticity. If the RP elected by BSR mechanism is valid, static RP will not work.
All routers in the PIM domain should be configured with this command and be specified
with the same RP address.
The new configuration overwrites the old one if you run the command for a second
time.
For related command, see display pim rp-info.
Example
# Configure 10.110.0.6 as a static RP.
[Quidway] multicast routing-enable
[Quidway] pim
[Quidway-pim] static-rp 10.110.0.6
To Next Page
Loading...
Need help?
General
